MIL-DTL-81963C
6.7 Subject term (key word) listing.
Breakaway torque
Bearings
Encoders
Dielectric withstanding voltage
Electrolytic corrosion
First article
Impedance
Insulation resistance
Pure tin
Qualification
Qualified Products List (QPL)
Quality conformance
Resolvers
Rotor shaft housing
Servomotor-tachometer generator
Servtorqs
Synchros
Tachometer generators
Transolvers
6.8 Soldering (see 3.4.15). Refer to Guideline 5 of MIL-HDBK-454, for additional information on
"Soldering". This document is available online at https://assist.daps.dla.mil from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.
6.9 International standardization agreements. Certain provisions of this specification are the subject of
international standardization agreement reached by the NATO Working Group on Analogue and Digital
Servocomponents (AC/301(SG/A)(WG/5)). When amendment, revision, or cancellation of this
specification is proposed which affects or violates the international agreement concerned, the preparing
activity will take appropriate reconciliation action through international standardization channels including
departmental standardization offices, if required.
6.10 Applicable international documentation. NATO documents applicable to this specification are
Allied Standard Publication (AStanP)-4, Volume 5990 Chapter 3, NATO Electronic/Electrical Technical
Recommendation, General Requirements and Common Tests; and AStanP-5, Volume 5990 Chapter 3,
NATO Quality Assessment Recommendation for Electronic/Electrical Parts, General Requirements and
Common Tests.
6.11 Qualification. Regarding documents and the specification sheet that cite MIL-DTL-81963 as a
direct reference with respect to products requiring qualification, awards will be made only for products
which are, at the time of award of contract, qualified for inclusion in the applicable Qualified Products List
whether or not such products have actually been so listed by that date. The attention of the suppliers is
called to this requirement, and manufacturers are urged to arrange to have the products they propose to
offer to the Federal Government tested for qualification in order that they may be eligible to be awarded
contracts or orders for the products covered by this specification. The activity responsible for the
Qualified Products List and information pertaining to qualification of products are listed in the applicable
general specification (see 3.2).
6.12 Insulating material (see 3.4.3). Refer to Guideline 11 of MIL-HDBK-454, for more information on
"Electrical Insulating Materials". This document is available online at https://assist.daps.dla.mil from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.
23
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business