MS17185 Clamp Synchro

Pages 1 - 2 - 3

MS17185A

Part or Identifying Number (PIN)	A	B	C	D	E	F
MS17185-1	.067 (1.702)	.037 (0.940)	.062 (1.575)	.078 (1.981)	.156 (3.962)	.040 (1.016)
MS17185-2	.101 (2.5654)	.037 (0.940)	.062 (1.575)	.078 (1.981)	.156 (3.962)	.040 (1.016)
MS17185-3	.130 (3.302)	.062 (1.575)	.094 (2.388)	.094 (2.388)	.188 (4.775)	.046 (1.168)
MS17185-4	.255 (6.477)	.062 (1.575)	.094 (2.388)	.094 (2.388)	.188 (4.775)	.046 (1.168)
MS17185-5	.165 (4.191)	.062 (1.575)	.094 (2.388)	.094 (2.388)	.188 (4.775)	.046 (1.168)

PIN	G	H	J	K	L
MS17185-1	.110 (2.794)	.110 (2.794)	.094 (2.388)	.188 (4.775)	4-48NF-2B
MS17185-2	.100 (2.54)	.110 (2.794)	.094 (2.388)	.188 (4.775)	4-48NF-2B
MS17185-3	.156 (3.962)	.156 (3.962)	.125 (3.175)	.250 (6.35)	6-40NF-2B
MS17185-4	.156 (3.962)	.156 (3.962)	.125 (3.175)	.250 (6.35)	6-40NF-2B
MS17185-5	.156 (3.962)	.156 (3.962)	.125 (3.175)	.250 (6.35)	6-40NF-2B

NOTE: Dimensions are in inches, metric equivalent are given for information only.

FIGURE 1. Clamp - Continued. Requirements:

Material: Steel, corrosion resisting, SAE AMS-STD-66, AISI-301, SAE-30301.

Mechanical properties: Tensile strength, 125,000 psi. Yield strength at 0.2 percent offset 75,000 psi.

Protective Treatment: Corrosion resisting steel shall be passivated. Dimensions: All dimensions are in inches unless otherwise specified. Tolerances: Unless otherwise specified, decimals ± .003, angles ± 1°. Surface roughness: 125√ ALL OVER in accordance with ASME B46.1. Workmanship: Break edges .010 - .015 Radius.

Threads: The threads shall be in accordance with FED-STD-H28.

This specification takes precedence over documents referenced herein.

The referenced documents form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.

Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes.